View Full Version : uneven cut

08-29-2004, 03:29 PM
have any of you guys experienced a Walker cutting uneven on a hill. I just purchased one 2 weeks ago and on a hill the low side always cuts lower. Is this typical of a walker

08-31-2004, 12:12 PM
no one has had this problem

08-31-2004, 12:20 PM
Not experienced with a Walker but it only makes sense that the low side would cut lower :)

I think most mowers will cut a little lower on the side of the deck that is hanging down hill. Some call it stepping.. I think. Less noticeable the higher you cut.

08-31-2004, 02:42 PM
Ya my mowers all do it. All of the ones i have had did it really... the fixed deck models seem to not do it as much though.

08-31-2004, 04:29 PM
My Snapper was doing this. I just started cutting diagonally up and down the hill and problem solved. It's a midmount, though.