PDA

View Full Version : Hunter I20 - Head stays up.


Summett
10-10-2004, 09:57 PM
Hello,

I just had an irrigation system installed and like it alot. but, one of the heads stays up after the zone runs. I had Hunter I20's installed.

I noticed that while it's running that water runs out between the part that pops up and the "nut" that screws on to the entire head. Then when the zone is done, the head doesn't return done.

I unscrewed the "nut" and took out the head and rinsed it out, but still doesn't retract.

Can anyone assist me? Thanks so much.

Mdirrigation
10-10-2004, 10:00 PM
Call the contractor and have him replace it.

Summett
10-10-2004, 10:12 PM
So you think the head is bad, mdirrigation? It seemed to work fine when he was here.

jerryrwm
10-10-2004, 10:33 PM
Yeah, there is something wrong in the flow-tube/seal/spring. It may be a damaged out-of-round cap, or a rolled wiper seal. It happens from time to time. Call the contractor and have him replace it. Hunter will warranty it no problem.

Jerry

TClawn
10-11-2004, 03:16 PM
what he said, ^^^^^^^^^^^^^^.

hunter is pretty good about warrantying their products.

Summett
10-12-2004, 09:13 AM
Called the contractor and got it replaced. Thanks for the help.

Critical Care
10-12-2004, 10:00 PM
By the way, the I20s are very nice - in my opinion.