PDA

View Full Version : 60" Z will not start?????


35kong
01-30-2005, 03:53 AM
Battery has a full charge, fuses are new, wires are excellent, just won't start. Any ideas on what else to check? The handle buttons are new in the lock position but it will not even roll over. No power.

Mowingman
01-30-2005, 10:05 AM
What make and model?

cgland
01-30-2005, 11:19 AM
Try asking in the Lawn Care forum

aklandscape
01-30-2005, 11:35 AM
If it won't even turn over it sounds like a safety switch. Look at the parking brake, make sure the pto switch is in the off position,and look at the safety switch under the seat.

35kong
01-31-2005, 01:02 AM
1999 kohler engine 22 or 25 horse- not for sure on the horse.

Mowingman
01-31-2005, 09:12 AM
Dead battery, safety switch you THINK is GOOD, another fuse you have not found yet, bad starter relay, bad starter switch, loose wire somewhere?
I hate electrical problems.

35kong
01-31-2005, 03:20 PM
I'm sending it to the shop. I'll end up taking it apart and then I'll just do more damage.

imograss
01-31-2005, 03:38 PM
Usually when NOTHING happens, it is most likely a safety switch. Under seat,PTO is ON, parking break/neautral switch. If youre lucky it will be a switch.

ToroMaster
01-31-2005, 06:48 PM
its your pto switch, spray it with wd-40.

captken
02-08-2005, 11:03 PM
if you checked your safety switches and fuses and they appear okay, jump the starter solonoid terminals with a screwdriver. If it starts, check the ignition switch.
I had the same problem with a Hustler Z. The ignition switch was bad.