PDA

View Full Version : Wanted Grass Catcher for Sarlo


apexlawn03
03-12-2005, 11:55 PM
I was wondering if you made contact with Sarlo about grass catcher? If not what would one cost custom made for my sarlo? What measurements are needed thank you.

PeterA
03-13-2005, 03:51 PM
I did call Sarlo. They are looking at our catcher but my experience is that these things often take quite a while to actually work out. Give me a call with the measurements of your mower opening. Also, if you could send or post a picture of the opening on your mower that would be helpful. As long as we can use a standard 3.3 cu ft. catcher body (what we use for the sutech mower) It should not be too difficult to make a hookup for your mower.

apexlawn03
03-13-2005, 08:38 PM
Thanks again Peter, I am off to work my fulltime job until wed. I will try to call you and try to put picture on line or email not to sure how to do but will give you a call wed or thursday thanks again.

apexlawn03
03-19-2005, 10:55 PM
hope pictures got sent and or posted

apexlawn03
03-19-2005, 11:02 PM
hope pictures help ithink I got it.

apexlawn03
03-19-2005, 11:15 PM
It looked like it worked

PeterA
03-20-2005, 02:49 AM
Apex,
Thanks for the pictures. We should be able to do a catcher for this mower easily. I do need one more measurement- how high is the opening? It looks from the pictures like it is about 5 inches.
Call me monday and I will arrange to get you a catcher.

apexlawn03
03-22-2005, 07:04 PM
The measurement is in center top to bottom is approx (4 and 1/4 inch ) It was from bottom of metal rail/ bar to top of deck. Do you think that metal bar across the dishcharge opening will be a problem with grass catching on bar?