Thread: Spitting Oil
View Single Post
Old 06-28-2005, 11:18 PM
Restrorob's Avatar
Restrorob Restrorob is offline
LawnSite Fanatic
Join Date: Apr 2005
Location: Show'n my truck off !
Posts: 11,026
Originally Posted by BrianK10
Hey all.

I've started to notice that at the end of the week of use, my Toro WB(36), on the left side of my transmission, it seems to be spitting a little bit of something out along the rod or shaft (whatever you may call it) that runs to the pulleys on each belt side. Its not ALOT, but its noticeable when you get down and look at it. Should I be worried? Any help or advice is appreciated.


This trans. is packed with a thick type grease and there are no seals on the output shafts,The bushings act as the seals. If this is a higher hour unit I would check for wear on the shaft bushing,If it's good and tight I wouldn't worry about a little slobber.
Originally Posted by piston slapper View Post
You never learn anything until you admit you don't know it all...
Originally Posted by MannsLawnService View Post
some times the man in my mirror isn't so smart...
"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
Reply With Quote
Page generated in 0.03796 seconds with 8 queries