View Single Post
  #1  
Old 08-25-2006, 05:00 PM
Jim@MilkyWay Jim@MilkyWay is offline
LawnSite Senior Member
 
Join Date: Mar 2006
Location: Dahlonega, GA.
Posts: 476
'95 7.3L/DITD pump housing seaping

The water pump that I replaced last year, appears to be seeping at block, just to left of thermostat housing. I have not tried to re-torque as I do not want to risk breaking housing. Is this a valid concern, or is it likely to even help. Do I just go ahead and disassemble? I have never put one together and had it leak before. I wonder if, A) I dropped the ball when sealing at install, B) the cheapo pump from auto zone is not flat where it needs to be, or C) if the notebook-paper thin gasket that came with pump should be replaced with a gasket which is a tiny bit thicker, like maybe .008 as opposed to .003, (thickness just a guess). Does anyone know if the tiny width difference has a bearing on the internal pump circulating action, owing to the fact that the pump housing has no back.
Reply With Quote
 
Page generated in 0.04312 seconds with 7 queries