View Single Post
  #3  
Old 11-08-2001, 04:23 PM
Scotlawncare's Avatar
Scotlawncare Scotlawncare is offline
LawnSite Senior Member
 
Join Date: Nov 2001
Location: Memphis, TN
Posts: 304
the mower was bought march or april of last year. The spindels are the ones with grease fittings but the problem is that I think they were not greased enough and the warranty was only one year. Motor has a two year warr. I seem to not be able to get the pulley's off it so I can check the barrings and shafts for wear. Both spindles move and cause vibration. I did bend the blade brake pully trying to use a three jaw puller so now I at least have to buy a pulley.

The reason I'm asking around is to not have to get out the torch and cut it in half to get it off. I'd rather replace barrings and maybe a shaft and pulley then the whole thing.
Reply With Quote
 
Page generated in 0.04187 seconds with 7 queries