View Single Post
Old 09-06-2007, 07:14 AM
RedRed RedRed is offline
LawnSite Member
Join Date: Jul 2004
Location: PA
Posts: 20
Are the bearings pressed onto the spindle or just interference fit? Also, how much slop is too much slop? I currently have about 2mm of up and down movement in the spindle. Before that I had absolutely zero up/down movement. I assume 2mm isn't too bad yet I don't want it to get out of hand and wipe out other parts as well.

Thanks for your replies.
Reply With Quote
Page generated in 0.03667 seconds with 8 queries