View Single Post
  #8  
Old 09-12-2007, 03:23 PM
Eric D's Avatar
Eric D Eric D is offline
LawnSite Senior Member
 
Join Date: May 2007
Location: Howell, MI
Posts: 294
Hold on a minute before taking it apart!

Quote:
Originally Posted by Louisianagames View Post
Another question or 2 before I get started.
How does the valve stem guides come out?
Do You have to pull the engine?
Louisianagames,

Welcome to the lawnsite.com. Before you start taking the engine apart run it for at least a few tanks of gas. If this unit had sat for sometime the cylinder walls and valve stems could have developed rust. It may take some running for this to clean up. You might just fine that with a little bit of run time all or most of the smoke clears up.

Regards,

Eric D
Reply With Quote
 
Page generated in 0.03932 seconds with 7 queries