View Single Post
  #22  
Old 01-16-2008, 06:25 PM
Envy Lawn Service's Avatar
Envy Lawn Service Envy Lawn Service is offline
LawnSite Fanatic
 
Join Date: Sep 2002
Location: North Carolina
Posts: 11,042
Quote:
Originally Posted by DARICEK LANDSCAPING View Post
going through old threads, these new carbs are adustable!! there is a small cylinder shaped hole that dead ends on the carb. you either need to drill it until it breaks through or there is a rubber cap you need to pry out. once you do, walla, you adjustment screw is awaiting your commands. it is very small though, you may need to file down your smaller screwdriver to fit in it.
Yeah, I was told RedMax had them like that too when I was asking about my hedge clippers.

Debating rather I'll do it myself or have it done under warranty this winter.
If it wasn't for the warranty, there would be no debate....
__________________
ENVY



"If you place a low value upon yourself, rest assured..... the world will not raise your price."

"The bitterness of poor quality lingers on long after the sweetness of cheap price is forgotten"
Reply With Quote
 
Page generated in 0.04820 seconds with 7 queries