View Single Post
  #1  
Old 07-17-2002, 01:20 PM
HLC HLC is offline
LawnSite Member
 
Join Date: Oct 2001
Location: Near Montgomery, AL
Posts: 128
Hustler Z ETI problem

I've had my Z (regular Z/25hp/60") a couple months now and the ETI is intermittent. I can cut for two hours and may show an increase of .7, .5, or sometimes nothing at all. I checked for voltage at the plug-in terminals on the back of the ETI with the engine running and with just the key turned on (engine not running) and it has always been zero. There is nothing obvious on a visual inspection. I know I have the warranty to take care of it, I just don't want to be down for this minor problem. It is, however, irritating me. Any suggestions would be appreciated.
Reply With Quote
 
Page generated in 0.04412 seconds with 7 queries