View Single Post
  #1  
Old 05-08-2009, 01:25 AM
ArizPestWeed's Avatar
ArizPestWeed ArizPestWeed is offline
LawnSite Bronze Member
 
Join Date: Apr 2004
Location: On the Toilet
Posts: 1,446
Make you own Ele Back Pack Sprayer

Sorry I couldn't put together a blog with instructions , this will have to do.
I know some of you all have already made your own using my idea , I would hope these pictures would be enough of a story so others can make their own.
Well , I will add a few words

The gravity flow BP is from SP Systems , you can order them from http://www.tessmanseed.com/index.htm out of St Paul Minnesota.
I buy 3 at a time

The pumps from Northern tool , I buy 4 at a time
The batteries off the net , 10 at a time .
Battery charger from http://www.batteriesplus.com/ , has alligator clips that easily connect to the tabs on the battery .
Never use charger in truck , just change out battery , takes 10 minutes or less

The metal plate or base that houses the battery and pump was made at a sheet metal shop .
You can make one your self , Ace hardware sells small pieces of sheet metal that you can use , drill holes to adhere metal plate to BP frame .

I used a drill to make a hole then a jig saw to make a slit for the velcro that holds the battery in place .

Drilled two holes
( not 4 , even though the pump has a place for 4 bolts )
For 2 bolts to mount the pump to the metal base .

In these photos , there is a ele switch to turn on & off the pump , I have made 20 of these ele pack back sprayers and only used a switch in a couple , I find there is no need for a switch.
Just pull the wire off the battery if you need to disconnect it .
There are no rules to making one , come up with your own design .

Any questions ?















Reply With Quote
 
Page generated in 0.04939 seconds with 7 queries