Thread: RWF, Inc.
View Single Post
  #852  
Old 10-15-2009, 12:42 AM
pitrack pitrack is offline
LawnSite Bronze Member
 
Join Date: Feb 2009
Location: Omaha, NE
Posts: 1,043
Quote:
Originally Posted by tthomass View Post
I took a few pictures today of this job I posted previously. I'm hoping the homeowner pulls the trigger and allows us to do the planting vs doing it themselves. Otherwise, so much for getting good pictures of the project

No, I don't like the cap. Future will be 2" standard unless the budget is just that tight. I should have pushed it here. Only issue I'll see though is doing curves. To have the supplier manufacture the curve is expensive vs cutting it in place with 1". I can manufacture 2" but its a different process than what I do with 1".
Is it just my eyes or are those steps not quite level in that third picture?
Reply With Quote
 
Page generated in 0.03639 seconds with 7 queries