View Single Post
  #1  
Old 03-27-2010, 08:19 PM
kena48's Avatar
kena48 kena48 is offline
LawnSite Member
 
Join Date: Mar 2010
Location: Choctaw, Oklahoma
Posts: 20
Mowing at Night - Ferris 2010 200Z

Well, I was bored and this took way too long, but it came out nice. These are 55W driving lights, that cost less than 20 bucks.

When I do get caught finishing up at night, there were two problems:

- seeing just forward of the line you are attempting to cut

- seeing the deck as you go around a tree truck etc.

Normal lawnmower headlights are fine for finding your way around, but these high mounted lights will actually help finish up the mowing.

They mounted where the roll bar folds and the wires go through the roll bar. That took the most time - using a long piece of bailing wire to pull the wires & plastic sleeves through. The new lights were spliced into the existing factory light kit - "prior" to the factory plug that the factory light kit plugs into. So all 4 lights then plug into the receptacle under the seat. That plug is on a 20 Amp accessory fuse.

So the factory light kit helps you see where you're going but these high lamps flood the area around the deck. It REALLY light up the night! ...and looks pretty cool too.
Attached Images
     

Last edited by kena48; 03-27-2010 at 08:28 PM.
Reply With Quote
 
Page generated in 0.04423 seconds with 8 queries