View Single Post
Old 04-08-2010, 04:21 PM
clean_cut's Avatar
clean_cut clean_cut is offline
LawnSite Bronze Member
Join Date: Jun 2009
Location: A small town, NC
Posts: 1,331
Originally Posted by DT Lawn Care View Post
Remove tension from the belts and check all of your spindles and pulleys for resistance, grease as needed. If everything spins fine, check your air gap on your PTO and adjust to spec. Good Luck

Also, are you too lazy to get underneath and remove the twine and crap hahaha
Thanks so much guys, I'll try to get to it later today.

No, I haven't been too lazy to remove the twine, well I probably could have, but I was quite busy. Finishing a 2 day cleanup, trimming hedges, mowing a lawn and picking up a new customer and cleaning his yard, Im liking the work though

Thanks again guys, God Bless!
If then God so clothe the grass, wich is today in the field, and tomorrow is cast into the oven; how much more [will he clothe] you, O ye of little faith? (Luke 12:28)

For if we live, we live to the Lord, and if we die, we die to the Lord. So then, whether we live or whether we die, we are the Lord's. (Romans 14:8)
Reply With Quote
Page generated in 0.03817 seconds with 8 queries