View Single Post
  #9  
Old 01-23-2011, 03:14 PM
DLAWNS's Avatar
DLAWNS DLAWNS is offline
LawnSite Fanatic
 
Join Date: May 2005
Location: Ocean County,New Jersey
Posts: 5,776
Quote:
Originally Posted by grassman177 View Post
that is alot of FF to cover that much metal!!! u use a gun and bucket of FF right?

did you sand all the rust off before applying FF? i did this to all of my hedge trimmers and hand tools that had become corroded.
yeah man...definitely used the undercoating gun and the gallon. If ya spray it right though it's not too much. I used less than two of the containers that go on the gun for the whole plow and dump insert. I went extra heavy on the plow too cause it was it was a fluid film virgin! hahaha Nah, didn't sand it first the fluid film ate right through the rust. I do plan on eventually sanding it down a bit and putting a coat of pain on it, but for now just wanted to "kill" the rust and prevent more.
__________________
Bill Depierro
Depierro Lawns Inc.
29 years old
11 years experience
www.standforstrength.com
 
Page generated in 0.04169 seconds with 7 queries