View Single Post
  #4  
Old 01-31-2011, 09:59 AM
dutch1's Avatar
dutch1 dutch1 is online now
LawnSite Silver Member
 
Join Date: Dec 2004
Location: Jayhawk
Posts: 2,164
This could be a ground/cable/starter problem as has been proposed. I have found on several occasions where the engine is having problems getting over TDC is that the cylinder is partially liquid locked. Pull the plug and isolate the plug wire so that it cannot spark to anything, then turn the engine over with the starter. If you happen to get gas spewing out of the plug hole, you may have a needle/seat in the carb that is not funtioning properly.
Reply With Quote
 
Page generated in 0.04560 seconds with 7 queries