View Single Post
Old 05-13-2011, 02:08 AM
flatlander42's Avatar
flatlander42 flatlander42 is offline
LawnSite Silver Member
Join Date: Jul 2008
Location: nebraska
Posts: 2,250
I'm using a Hobart Handler 187.....w/o looking that number may be wrong. That is a MIG welder for those that don't know. But when it is cranked up it is supposed to be good for 5/16" single pass. And I have been beveling and doing multi pass welds. So I know I have good penetration, and I don't grind off welds unless there is clearance reasons. So overall, I am confident for the most part....just that tiny voice in my head that just worries all of the time!!!
I'm not a Miracle Worker, if it looks like crap now, it will look like crap with stripes when I am done.

My E-450 Dovetail Van project thread.
Reply With Quote
Page generated in 0.03665 seconds with 8 queries