View Single Post
  #86  
Old 05-16-2011, 06:42 PM
flatlander42's Avatar
flatlander42 flatlander42 is offline
LawnSite Silver Member
 
Join Date: Jul 2008
Location: nebraska
Posts: 2,250
Quote:
Originally Posted by XLS View Post
subscribed. Looks good
I dont think the bottoming out is as big of a deal as you think ours is alot lower and it takes a sharp spot to hit . I think the wheel releifs will be the major problem at this point when its loaded and has grass it looks like it would be less then 2'' and the truck will need 4'' of wheel travel for suspension travel alone . By the look i am betting the entire side of those rails will be cut in by the time its finished , Good luck ,great project
When there is nothing on the truck there is enough room for about 4 fingers to fit between the side and the tire. With both mowers on it there is room for about 3 fingers. Only the pinky wouldnt fit.


I plan on loading both mowers and going down my street and hitting some of the big dips and seeing if the tire rubs. Then let the cutting begin!.......if needed.
__________________
I'm not a Miracle Worker, if it looks like crap now, it will look like crap with stripes when I am done.

My E-450 Dovetail Van project thread.
http://www.lawnsite.com/showthread.php?t=351062&page=7
Reply With Quote
 
Page generated in 0.03777 seconds with 7 queries