View Single Post
  #175  
Old 08-28-2011, 11:48 AM
TLS's Avatar
TLS TLS is offline
LawnSite Fanatic
 
Join Date: Jan 2000
Location: N&W Philadelphia Suburbs
Posts: 7,938
Quote:
Originally Posted by alanauer View Post
How in the world do you measure blade RPMs?
"QOC" is quality of cut?

Another issue: somebody mentioned his blades have an extraordinarily long cutting edge. I assumed (from wear patterns) that all the cutting was done at the tip or maybe just the outer inch. But in a mulching setup where the blade is supposed to take multiple whacks at each piece of cut grass, would a longer cutting edge facilitate this?
I use a Tiny Tach tachometer. Inductive pickup wire on spark plug wire. Keeps a running total of engine operation hours and while engine is running it displays RPM's in 10 RPM increments.

Yes...QOC is Quality Of Cut

These are full length sharpened blades (well almost full length). This aids in high speed high volume cutting quality.
__________________
TLS
2004 GMC 2500HD Reg Cab BOSS 9.2 V-Plow
2013 eXmark LazerZ X-Series 60" 34hp EFI (RED) Kohler
2006 Hustler SuperZ 28EFI 60" Power Chute Design OCDC SOLD!
Perma-green Magnum
1996 48" SCAG Belt WB 14hp Kawasaki Classic Deck
Echo 2 strokes PB-755 & SRM 280
Eastman WM20H 20" Commercial Push mower (NEW for 2013)
Commercial Lawnboy trim mower 3-FOR SALE!http://www.lawnsite.com/showthread.php?t=424203
Solo since 1980
Reply With Quote
 
Page generated in 0.03174 seconds with 7 queries