View Single Post
  #27  
Old 10-18-2011, 06:49 PM
ed2hess's Avatar
ed2hess ed2hess is offline
LawnSite Fanatic
 
Join Date: Nov 2002
Location: Austin Texas 78727
Posts: 11,842
Quote:
Originally Posted by Terry Metro Lawn View Post
Hi Ed,

What regulator did you install? Typically the idle screw is backed all the way off. Run mixture is dependent on the engine.

Some starting problems can be caused by the lockoff not closing and the mixture being too rich.

Yes, since propane is already a vapor it will run slightly hotter than gasoline since there is no "wash down" of the cylinder. It really shouldn't affect operation though.

This may sound like a stupid question but is the tank mounted so that the "pin" is in it's mounting?
Reg is a Beam Model T60...I know about the pin and it is correct.
Reply With Quote
 
Page generated in 0.03745 seconds with 7 queries