Thread: New to me mower
View Single Post
  #8  
Old 12-13-2011, 09:17 AM
WrightCommercial WrightCommercial is offline
Sponsor
 
Join Date: Apr 2008
Location: Frederick, MD
Posts: 497
Bill,

The 93460024 part was replaced by 93460031, both numbers will get you the same part. The hydro belt can be tricky, most think the clutch has to come off but that is not the case. When putting a new belt on loop the new belt over top the idler arm between the pivot tube and the idler pulley (tight clearence), slip the front section up and around the clutch then wrap the right side hydro pulley and then the left side hydro pulley. Two sets of hands help at the end since the idler will have to be compressed to wrap the last pulley which can be tough by yourself.

Best Regards
Wright Mfg.
Reply With Quote
 
Page generated in 0.04857 seconds with 7 queries