View Single Post
Old 02-29-2012, 02:06 AM
LawnSite Bronze Member
Join Date: Feb 2010
Location: Birmingham,MI
Posts: 1,413
Did you attempted to pull PVC? OR is that just for the 3/4" Poly? Thats a big job to tackle in two days. Clean looking valves though. At leased better than i have seen before. Only advise is when one of the t's or elbow's break in the valve box, you use so little pvc in between, OUT COME ALL THE VALVES TO REDO THE SPACING IN BETWEEN EACH.

Best thing to do is to get the manifolds so there is less change of them breaking and you dont have to spin or cut the valve, just spin the coupler and its off.

Insured and Licensed
Reply With Quote
Page generated in 0.04375 seconds with 8 queries