Thread: New to me mower
View Single Post
  #14  
Old 04-13-2012, 09:02 AM
Turf Dawg's Avatar
Turf Dawg Turf Dawg is offline
LawnSite Gold Member
 
Join Date: Aug 2006
Location: Gainesville Texas
Posts: 3,649
Quote:
Originally Posted by WrightCommercial View Post
Turf Dawg,

Will check with the weld manager, most likely it was pulled from the jig to quick and as the metal cooled it pulled it out of shape. It is best to force the bolt holes to line up instead of drilling them out so there is no chance of blade interference. If there is no way to force it let us know and we will replace it.

Best Regards
Wright Mfg.
Good morning,
The trim side could probably be pryed to line up. The discharge side is too far off. Also, is there supposed to be a gap large enough at the rear that you can put your fingers in [vertical] between the mulch plate and deck?
Reply With Quote
 
Page generated in 0.04433 seconds with 7 queries