View Single Post
  #1  
Old 04-14-2012, 10:36 AM
tadpole's Avatar
tadpole tadpole is offline
LawnSite Bronze Member
 
Join Date: Jun 2008
Location: Pensacola, Florida
Posts: 1,177
Bubbler - Water Height

I usually avoid decorative water features, but I had to replace the pump in an urn bubbler for an existing customer. I installed a 500 gph mag drive which, as best that I could determine, is the standard size for this type of water feature. The customer would like the water to have a greater height than the approx 2 -3 " that it presently has.
My question is: Instead of moving up to the next larger size pump (700 gph). could I instead place a cap on the existing 1/2" stand pipe and drill a smaller than 1/2" hole to increase the PSI? How much smaller hole would I need to drill to get about 6" in water height?
__________________
"Everybody is ignorant, only on different subjects." - Will Rogers
Ripples
Aquatic Habitats
Reply With Quote
 
Page generated in 0.03890 seconds with 7 queries