View Single Post
  #31  
Old 06-02-2012, 08:43 AM
Razorblades Razorblades is online now
LawnSite Senior Member
 
Join Date: Apr 2007
Location: Prattsville,AR
Posts: 752
Quote:
Originally Posted by GMLC View Post
Right now Im still running OEM blades. But yesterday I bought a set of Stens blades from my dealer which are factory replacements (Gravely owns Stens) but are thinner than the stock blades. He claims you get a little more blade tip speed and has had good results. I kinda gave him the look and said I will give them a try. Im going to put them on this weekend and will cut with them on Monday and report back. I have never run thinner blades. Have you ever heard of better blade tip speeds with them?
Posted via Mobile Device
Blade tip speed should be the same as with other blades because that engine should have a max. rpm setting of about 3600 loaded (with blades engaged)or unloaded. That is one function of the governor on these engines with carbs is to get the engine to max rpms under load and to help keep it operating at that rpm whenever possible.

If you put a tachometer on the engine and check the rpms (not a bad idea anyway to make sure it is running at the 3600 rpm setting) unloaded and then after you engage the blades, you should see the engine have a short drop off in rpm's and then it should gain back the rpms back to within 50 rpms of original reading, if the governor is set properly.

With the bagger going, I'm not sure if the governor will be able to compensate for that much extra rotational mass being turned.
Reply With Quote
 
Page generated in 0.03802 seconds with 7 queries