Quote:
Originally Posted by GMLC
mtmower if it makes you feel any better my cut height is a bit over 1/8" off compared to the guage. I was happy with that considering Im running less air pressure and my floor not being perfect.
Posted via Mobile Device
|
Could you not correct this either due to not being able to get it into transport position? I'm going to have to drop my deck a little still. At 1/8" off from the gauge, it's all I can do to get it to latch and unlatch. My wife can't even do it. With 1/8" pitch it did a pretty nice job. Emailed my rep and he recommends 1/4" pitch, which with the OEM humped blades will put it off by a little over 1/4" from the gauge. If the straight blades work better and I switch to them this will offset the inaccuracy a little.
Yesterday I tried cutting a small area that had not been cut yet this year and was tall (12"-15"), stalky, and not very thick and it left skippers even at slow speed which surprised me. The deck did have a good deal of clippings packed under it so this may have been part of the cause.