View Single Post
  #364  
Old 06-15-2012, 04:04 PM
GMLC's Avatar
GMLC GMLC is offline
LawnSite Platinum Member
 
Join Date: Jun 2010
Location: New Hampshire
Posts: 4,363
I installed my stripe kit this morning. Only took about 20 minutes, very easy to install. I also had the same problem as mtmower and ProStreetCamaro, the glossy side will not face the deck as the instructions say. The holes will not line up that way. Only tools needed are a 3/8" air ratchet with a T45 torx bit. Just jack up the rear end and take off the tires to get access to the rear of the deck.

I did stripe with it today with mixed results. Some lawns striped better and some not as good as usual. I will report back after I use it more.
Attached Images
     
Reply With Quote
 
Page generated in 0.04155 seconds with 8 queries