View Single Post
Old 06-17-2012, 09:17 PM
dutch1's Avatar
dutch1 dutch1 is offline
LawnSite Silver Member
Join Date: Dec 2004
Location: Jayhawk
Posts: 2,227
To remove built up carbon in a muffler, I fill it with as much kerosene as possible then set it on a concrete block and use a torch to get the kerosene to burn. Let it burn out, then tap the muffler gently with a small hammer or screwdriver then blow out with air. This may not be an OSHA approved method but if works for me. The muffler has some baffles in it but a catalytic convertor is something I'm not aware of.
Reply With Quote
Page generated in 0.03589 seconds with 8 queries