View Single Post
  #156  
Old 06-20-2012, 05:56 AM
Snapper Jack Snapper Jack is offline
LawnSite Senior Member
 
Join Date: May 2010
Location: weaverville, NC
Posts: 517
Quote:
Originally Posted by fatboynormmie View Post
Hey GMLC I have some Oregon 91-623 SUPER high lifts I run on my older 152z.The are 3" wide notch blades and have a 1 1/2" lift.They cut nice and discharge super far in dry conditions.The only problem I have with them is they zap alot of hp from the motor and really draw down 25hp kaw in wet conditions.I might try a set of the factory 452 blades to see how they perform.
I use those blades occasionally for a bi-weekly account using a FB460V(12.5 HP) grind the lift down to 1 1/4",re-balance, makes big difference not sapping the HP and discharging is about the same or better cuz the strain on the engine has been reduced,at least that's what I've experienced.
Reply With Quote
 
Page generated in 0.03767 seconds with 7 queries