View Single Post
  #386  
Old 06-27-2012, 09:30 PM
ProStreetCamaro's Avatar
ProStreetCamaro ProStreetCamaro is offline
LawnSite Gold Member
 
Join Date: Apr 2004
Location: Gaithersburg Maryland
Posts: 3,772
My gas gauge has started to stick a bit. The level wont raise as I am filling tank. After I cut a lawn it has raised to where it should be.

Also the threads where the rubber handle stop threads on are stripped. I had to cut one day with the handle on one side down much lower than the other side. That evening I had to pull it off and put a nut on it then push it back though the stripped threads and put a second nut on the back side in order to get it to stay in place. This is something gravely should have done in the first place. That is absolutely r e t a r d e d that they did not have a nut on both sides to lock it in place.
__________________
2013 Gravely 460Z 29EFI
2011 Gravely 36GR
2008 Gravely 160Z
2004 Gravely 34Z
1998 Lazer Z HP 48 (old faithful)

Last edited by ProStreetCamaro; 06-27-2012 at 09:38 PM.
Reply With Quote
 
Page generated in 0.04752 seconds with 7 queries