Thread: Engine Rebuild
View Single Post
  #7  
Old 07-07-2012, 04:05 PM
BigFish's Avatar
BigFish BigFish is offline
LawnSite Bronze Member
 
Join Date: Jul 2008
Location: chesapeake, va
Posts: 1,657
So...... let me get this straight.
You say you rebuilt this motor ?
BUT :

1. You reused the headgasket.
2. You reused the carb gasket/s.
3. You didn't do a thing to the valves.

Did you measure the bore for wear, out of round, taper?.... Didn't think so.
Did you hone/ deglaze the cyl.?..... Didn't think so.
Did you check the rings for correct end gap?..... Didn't think so.

"But it don't got no compression"

Manuals are fairly easy to come by. I've recommended this site several times as a good place to get manuals and parts: http://www.mymowerparts.com/pdf/Tecu...epair-Manuals/
__________________
" But let me tell you something ,folks: You can't fix stupid! There's not a pill you can take, there's not a class you can go to. Stupid is forever!"

......AMF!
Reply With Quote
 
Page generated in 0.03346 seconds with 7 queries