View Single Post
  #7  
Old 08-26-2012, 05:36 PM
irrig8r irrig8r is offline
LawnSite Platinum Member
 
Join Date: Dec 2004
Location: Silicon Valley, CA
Posts: 4,545
Quote:
Originally Posted by SoCalLandscapeMgmt View Post
Try erasing all of the programs and starting over. That controller has non volatile memory so just unplugging it will not fully reset it if the problem is a programming issue. The command to erase the program is to turn the dial to the program then press 1 - 3 - 7 - 9 and then enter. Do that for each program and then power the controller down, pull the battery and let it sit for a good 15 minutes and then power it back up and re-program.
I thought it was the MC Plus-B that had the NVM.

Edit:
I may be wrong. Found a 1997 MC Plus manual online that says it has a NVM and a 9 V alkaline for current time.
All I can figure is that the one on one of my jobs with the NiCad batteries must be an earlier version.
__________________
Landscaper. Irrigator. Illuminator. Music lover. Coffee drinker.

Last edited by irrig8r; 08-26-2012 at 05:45 PM.
Reply With Quote
 
Page generated in 0.03678 seconds with 7 queries