View Single Post
  #3  
Old 09-23-2012, 09:20 PM
DLCS's Avatar
DLCS DLCS is offline
LawnSite Platinum Member
 
Join Date: Apr 2002
Location: Illinois
Posts: 4,365
Yes, the warranty is up, I don't use mine like most do. lol I miced the shaft and the top is worn down considerably compared to where the bottom shaft spins on the lower bearing. The bearings checked out great, just the top of the shaft was worn. The pulley was tight as could be. What I find that is so strange is one, this kind of wear withg such low hours and two, the bearings are not worn at all, I even put the mic to them. I have never ran anythin though it other than Triplet so no abrasives but the chemilces don't even contact this piece. Accordiing to the manual i can buy just the shaft but I don't see how this could wear like this other than a defect in the material, or how the heat treating of the steel shaft. Anyone else have this problem?
__________________
Mike

2013 haulmark 18' trailer
2013 John Deere 52' walkbehind
2012 Gator with skid sprayer
2010 Turfco T-3000
2008 JD 997
2006 JD 647a
2004 JD 757 w/ 3 bag & Iron MCS
2002 JD 757 w/ 2 bag MCS
2002 JD 757
Stihl, Echo, Tanka 2 strokes
Big Tex trailers
Tons of other equipment
Reply With Quote
 
Page generated in 0.04191 seconds with 7 queries