View Single Post
  #4  
Old 09-26-2012, 06:55 AM
PTP PTP is offline
LawnSite Bronze Member
 
Join Date: Nov 2004
Location: Tulsa
Posts: 1,318
Absolutely it can be done. I have done it multiple times with great success.

However, there are a few things that you need to be aware of. First, the bolt holes on the new spindles are just a tad bit small. Just drill them out and you will be fine.

Second, the center shaft on the new Skag spindles are a larger diameter than the old Wright spindles. This means that the old collars won't fit and she will have to buy Scag callers to go along with the Skag spindles. The pulleys will be fine though.

Last, make sure that you give it a lots and lots of grease the first time. It takes 50 shots of grease or so in order to make it come out of the release valve. Do those things and it will work out great. I am about to go and do one this morning.
Posted via Mobile Device
Reply With Quote
 
Page generated in 0.03542 seconds with 7 queries