View Single Post
  #2  
Old 09-29-2012, 05:20 PM
teckjohn teckjohn is offline
LawnSite Member
 
Join Date: Aug 2010
Location: Enterprise Alabama
Posts: 226
disassemble all lines and wheel motor on the side that went bad

disassemble all lines, coolers, wheel motor and filter head and remove hydro tank and flush it on the side that went bad. Kerosene will clean all the parts and then you will want to use a pressure washer to flush lines and then re wash it in kerosene and use a air hose to blow off all parts. You dont want to have a little piece of metal ruin your new pump. Pull the wheel off the good side and take lines off and see if it has metal in it
Reply With Quote
 
Page generated in 0.03487 seconds with 7 queries