View Single Post
  #13  
Old 10-01-2012, 11:34 PM
G. Ramey's Avatar
G. Ramey G. Ramey is offline
LawnSite Senior Member
 
Join Date: Jun 2006
Location: clarkesville, ga
Posts: 371
I use a 4 foot high lift to change blades on my zero turn. I back the mower up until the rear end is hanging over the tailgate, then I can jack the mower up as high as I need to without the rear end of the mower hitting the ground. Then I can stand on the ground on either side of the trailer and zip the blades off with my impact without ever getting more than an arm under the mower. It's the quickest easiest way of changing blades that I have found. If i'm cutting by myself I can also use the high lift to get the mower unstuck. It's also much smaller than any dedicated lawnmower lift. I just throw it on the trailer and carry it with me. The only maintenance required is an occasional squirt of WD40.
Reply With Quote
 
Page generated in 0.04200 seconds with 7 queries