View Single Post
  #17  
Old 10-07-2012, 12:13 PM
Billsz28 Billsz28 is offline
LawnSite Member
 
Join Date: Jun 2012
Location: Doylestown, pennaylvania
Posts: 70
Ok I torqued the head in 2 steps first to ~160 in/lb then finally to 315 in/lb in the order designated by the instructions. Torqued the rocker arm pivot bolt to 124 in/lb does that sound about right? I did clean up the head with light sandpaper on a level surface.
Posted via Mobile Device
Reply With Quote
 
Page generated in 0.03789 seconds with 7 queries