View Single Post
Old 10-22-2012, 11:23 AM
Kiril Kiril is offline
LawnSite Fanatic
Join Date: Jun 2007
Location: District 9 CA
Posts: 18,365
Originally Posted by Wet_Boots View Post
California plumbing makes swapping stops a piece of cake, since they go in for the compression connector on the supply side.
Still have to drain the plumbing, then flush, which is a PIA I'd rather avoid given I have to go onto the roof 3 times to do it.

Originally Posted by Wet_Boots View Post
Also, invest ten bucks in a Korky fill valve, they have trustworthy recommendations on their quietness. (I'd recommend the ultra-quiet one I installed, but it was a no-name import, like me )
If I were planning on keeping the cheapo toilet I would most likely be looking at new fill valves, however I have two Toto's waiting to be installed and it is highly unlikely I will be swapping anything out on those.
Reply With Quote
Page generated in 0.03807 seconds with 8 queries