View Single Post
Old 10-26-2012, 05:17 PM
piston slapper's Avatar
piston slapper piston slapper is offline
LawnSite Platinum Member
Join Date: Mar 2010
Location: Tampa Fl
Posts: 4,236
#6 is a driver for removing spindle shafts from spindles that use a thru bolt and nut to hold the blades on...Scag...Exmark...fits most of them.
I rounded the head of a dixie chopper blade bolt into a circle and cut a 1/4 inch slot in it.
this allows it to drive right past the key stock if it is still in the shaft..
Bump it with an air hammer....
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough...
Do The Work
Reply With Quote
Page generated in 0.04113 seconds with 8 queries