View Single Post
  #10  
Old 11-03-2012, 02:04 AM
1idejim's Avatar
1idejim 1idejim is offline
LawnSite Fanatic
 
Join Date: Jul 2009
Location: State of Jefferson
Posts: 7,043
Quote:
Originally Posted by RhettMan View Post
When controller off, no flow from drain tile...
when controller on, MV wire in, zone wire out, no flow
when controller on, MV wire in, zone wire in, flow from tile.

I outfitted all sprays nozzles on the zone with Closed VAN's to see if the meter would stop completely, sure enough, still rolling a few gpm's worth when the zone valve is wired in.

Perhaps worth noting, the heads and valves in question are on opposite sides of the house. the outlet from the zone valves is pointing staight toward the new house addition which now divides the yard, (or valve and heads).

___ Thanks guys

P.S. what are my options on tracking the lateral line by cutting into it near the located valve, and attaching a (for lack of the correct term, "chatterbox", "sound-maker", "water pipe tracker".

I suppose a could run a wire down the lateral and track it with a 521, seems that might be foiled by a 90 , etc.

anyway, thanks again yall! (you fixed the hammer issue btw

Close it off again and induce air. Make a .25 npt adapter and start with low pressure. Increase pressure as needed. Sometimes a mixture of air and water has to be used but air will surface when water won't.

Don't get in too much of a hurry to cut or dig, you'll end up with a more harmonious outcome
Posted via Mobile Device
Reply With Quote
 
Page generated in 0.04463 seconds with 7 queries