View Single Post
  #1  
Old 11-04-2012, 04:20 PM
hackitdown hackitdown is offline
LawnSite Silver Member
 
Join Date: Apr 2004
Location: Groton, MA
Posts: 2,233
Greasing spindles

I just replaced 3 spindle housings and spindle bearings on an Exmark Lazer HP. I replaced the Exmark sealed bearing with aftermarket Oregon parts since they cost so much less. The new bearing housings have grease fittings on the side of the housings. The housings are bolted under the deck.

Since both my mowers have never required grease in the spindles, I don't know how much grease to put in there first time, and I don't know how often to grease, or how much goes in routinely. Exmark only specifies anti-seize for assembly.

What is the typical way to grease these bearings? Thanks...
__________________

Supah-Duty
Exmark-Gravely-Scag
Stihl-Redmax
Reply With Quote
 
Page generated in 0.03857 seconds with 7 queries