View Single Post
  #7  
Old 11-05-2012, 07:41 AM
hackitdown hackitdown is offline
LawnSite Silver Member
 
Join Date: Apr 2004
Location: Groton, MA
Posts: 2,242
Quote:
Originally Posted by BigFish View Post
A word about Oregon spindles with sealed bearings and a grease fitting.
The ones we use, and we use a lot of em , have sealed bearings, that is, the bearing is sealed on both sides. So you can pump yer a$$ off and very little, if any grease is gonna make it to the innerds of the brngs!
I verified this by taking a new unit apart.
So if ya wanna grease em, ya might wanna pop the bearings out and remove the inner seals.
Now...back to the race!
Thanks for the info. I don't know how to tell the difference between sealed and unsealed bearings.

I don't see that there is any place for excess grease to squeeze out, so it is guesswork to know when to stop. Does it squeeze out at the bottom of the housing between the bearing and the housing?
__________________

Supah-Duty
Exmark-Gravely-Scag
Stihl-Redmax
Reply With Quote
 
Page generated in 0.03538 seconds with 7 queries