View Single Post
Old 11-07-2012, 05:27 PM
BigFish's Avatar
BigFish BigFish is offline
LawnSite Silver Member
Join Date: Jul 2008
Location: chesapeake, va
Posts: 2,456
Originally Posted by piston slapper View Post
Here's a few more...should be pretty simple..????
Alright, lets see......
Ya got yer plastic two cycle piston support and ring compressor set ( color coordinated, I might add!), ya got a piston stop, ya got sumpin' I never used, ya got an L head valve keeper installer, (compressor, remover), ya got a control wire Z bender ( I like my home made one better, crisper bends), 'nuther side valve spring compressor, ya got yer starter C-ring install and remove tools,
Ya got yer 4 way carb jet tool (useless, by the way), ya got a carb offset screwdriver,
ya got a tang bender, ya got a crank holder for when you leakdown test, and some funky lookin' magnetic ended pocket clipped promotional thingamajig, and a pin spanner driver, that I'm sure is handy, but I ain't used one! And your guide pusher setup.
It ain't rocket science! far.

'Course if yer house has more wheels than yer truck...
" Old age ain't for sissies "
Reply With Quote
Page generated in 0.03368 seconds with 8 queries