View Single Post
  #47  
Old 11-15-2012, 07:10 PM
DaveyBlue32 DaveyBlue32 is offline
LawnSite Member
 
Join Date: Sep 2011
Location: Collegeville,PA
Posts: 112
[QUOTE=Doublewide6;4583901]
Quote:
Originally Posted by TOOLSHACK View Post
The carb on the SRM-261T is ADJUSTABLE !!! The adjustment screw is hidden under a "limiter cap" that is required by the EPA. The limiter cap is located inside the hole on the top of the carb... where the rotor is (part that swivels when throttle cable is pulled). If you have a GOOD dealer in your area, he should have a service bulletin that shows him (and you) how to adjust the carb. If you run 89 octane and a synthetic oil at the CORRECT mixture, keep your air filter clean, and keep debris from building up on the exterior of the carb.... you shouldn't have any problems or need any adjustments.

I did not know about this hidden jet screw. I took a look at an old trimmer that was not running due to some carb issues and got it running. Here is a link to a small video I made on how to locate that jet screw. Thanks for posting this info.

http://www.youtube.com/watch?v=mmbZ5ArpJq0
Reply With Quote
 
Page generated in 0.03391 seconds with 7 queries