View Single Post
Old 11-17-2012, 08:38 AM
jsslawncare's Avatar
jsslawncare jsslawncare is offline
LawnSite Bronze Member
Join Date: Feb 2011
Location: North Georgia
Posts: 1,677
I use to manage an auto machine shop. I ran the block department(I did all the machine work on all engine blocks) and I had a computer set up beside my boring bar. So after each set up, E-bay motors was my choice. I was like the OP every 3 to 6 minutes.

CNC is any machine that is Computer numerical control.
All equipment is wore out. <- Never mind. All equipment has been repainted and with new decals. It's like I have new mower's again!
48" Ferris WB
36" Ferris WB
All Echo hand helds
<- That's how I feel at the end of the day.

Last edited by jsslawncare; 11-17-2012 at 08:46 AM.
Reply With Quote
Page generated in 0.03611 seconds with 8 queries