View Single Post
  #7  
Old 11-18-2012, 08:54 PM
DiyDave DiyDave is offline
LawnSite Bronze Member
 
Join Date: Jan 2007
Location: Gambrills, MD
Posts: 1,695
Rich, I think you are right.

I have the worm drive clamps, on my 28 EFI Kohler. They keep loosening up, so I keep a 1/4" nut driver near where the mower is parked on the trailer. That keeps 3 of the 4 tight. The other baXXXrd is at an angle that I have to use the snap on 1/4 inch drive u joint on, to tighten it, every time I change the blades down at the shop. That oil cooler is nothing but trouble, with worm drive clamps. You wouldn't have a part number and source for the clamps pictured in your post, wouldja?? Thanks, Dave
Reply With Quote
 
Page generated in 0.03413 seconds with 7 queries