View Single Post
  #17  
Old 11-20-2012, 04:00 PM
The Lawn Ranger CT.'s Avatar
The Lawn Ranger CT. The Lawn Ranger CT. is offline
LawnSite Member
 
Join Date: May 2010
Location: westhaven Ct
Posts: 194
If your just able to squirt starter fluid into the carb and it starts,..then I'd say its the carb,...not that its bad, I'm still thinking the main jet on the bottom is clogged~
I'm gonna try to send you a link to where these jets are located on the carb, the link should bring you to a photo of a breakdown of the carb and parts,...
#25, #26 & #29 are main & nozzle jets that can be clogged, they unscrew out, but over time can set in and be very hard to remove if at all , if that happens best to make sure that area of the carb is being soaked good and then blown clean with an air compressor and hopefully will clean out any dirt.
Note also be careful not to loose the float needle#16 (connected to the float) while doing all this~

http://www.partstree.com/parts/?lc=k...0V&dn=99030029
Reply With Quote
 
Page generated in 0.03871 seconds with 7 queries