View Single Post
Old 11-28-2012, 09:33 AM
piston slapper's Avatar
piston slapper piston slapper is offline
LawnSite Platinum Member
Join Date: Mar 2010
Location: Tampa Fl
Posts: 4,221
Originally Posted by piston slapper View Post
How does it run now...??
I always polish the pistons with a small wire toothbrush..using a side to side motion.
If there are any scratches in the piston they should not be in line with the stroke...
Fine scratches paralell with the rings will hold a small amount of fuel that will cushion the piston from digging into the cylinder..just like crosshatches on a cylinder...
If I can remember...I will post a pic of the process on Monday makes them look like new..
Here you go Ed...Its easier to show you than to explain it..
Attached Images
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough...
Do The Work
Reply With Quote
Page generated in 0.04327 seconds with 9 queries