View Single Post
  #24  
Old 12-10-2012, 09:59 PM
1idejim's Avatar
1idejim 1idejim is online now
LawnSite Fanatic
 
Join Date: Jul 2009
Location: State of Jefferson
Posts: 6,993
Quote:
Originally Posted by ed2hess View Post
I am not into measuring current on selenoids but I do use meter for measuring resistance at the controller. And for that I need a good clamp on device.....sears one is poor. I want a hard wire running from the plug on the meter to the clamp on with no slip fit devices in between. I dont want to be guessing whether their is a open in my meter lead goofing up my measurements.
There should be no guesswork, they either work or they don't.

With the exception of low voltage lighting guys i prolly use DMMs as much if not more than the average bear and i don't take issue with removable leads or plugin adapters.

I did recently look at a buddies meter, he thought it was broke. The leads were in the wrong ports.
Posted via Mobile Device
Reply With Quote
 
Page generated in 0.03170 seconds with 7 queries